75ZT Community

[Bolin]

Hi folks!

I am looking for a bracket for the later Highline radio unit with dual tuners (radio part no. XQC000240, can he seen here: https://www.xdalys.lt/en/product/12398366248/). It will also fit the BMW BM54 and BM54 Back radios.

It sits in the spare wheel well on the driver's side, I think it was fitted new to cars from 2005 and maybe late 2004. If anyone has removed their Highline and ...

[Ed3]

Can I use 3a screw connectors on a towbar wiring loom inside the car boot?

I have fitted the towbar and sockets to the exterior and just need to connect the second hand wiring loom with relays inside the boot to the wires going to the rear light clusters (left & right). I ordered choc box connectors and they sent small 3 amp screw connectors for use in each choc box. Does anyone know if ...

[stevenkeyte]

Can anyone recommend a supplier of rear silencers for the 2.5L? Mine is going to need changing in the near future and I'm just wondering what are peoples experiences of after-market boxes? I see Klarius manufacture one for £131.99 from Euro Car Parts and Rimmers supply an aftermarket unit for £117 + VAT. My 'go to' source would have been DMGRS, but unfortunately they don't have any in stock,

Steve

[Mick]

Meet as usual to be held at Kings Road Calf Heath WV10 7DU

Put your name down if you are attending on the Nano Meet forum.

https://www.midlandsnanomeets.co.uk/for ... ae4d19af74

[stevenkeyte]

I think I've identified a suitable replacement for the long time unobtainable two piece clip which fixes the bumper to the front wing on our cars, usually know as the 'fir tree clip'.
The original clips seem to have been manufactured by a company called TRW and they produce a very similar two piece clip, these are supplied by a retailer called JetPress and their reference number for the clip is TPF071, here's a link ...

[stevenkeyte]

I've just been reading the 'How To' detailing how to align the front bumper on facelift models on the other side.. At one point in the 'How To' it seems to suggest removing the fir tree clip that secures the bumper to the front wing at the uppermost edge of the 'S' line of the wing / bumper:

Raising the slam panel is important because it in turn raises the headlights, allowing vertical movement of ...

[Trebor]

he next Midlands Nano Meet will take place on Saturday 31 May 2025, please visit the Nano website below ( free to join) and put your name down if attending or post your names on here and either myself or Arctic will post them across

https://www.midlandsnanomeets.co.uk/forum/viewforum.php?f=245

[Bermudan 75]

https://www.practicalclassics.co.uk/mag ... june-2025/

Three articles included in this issue concerning the 75/MG.

[Ed3]

Just checking which major parts do I leave off when fitting the towbar? The towbar seems to replace the large horizontal support bar? But do I assume the two very large polystyrene padding sections are also left off the car?

At the centre of the rear of the car (and only seen with the bumper off) there is a plastic or polythene plug that needs a hole made in it to push the wiring through. ...

[Bermudan 75]

I have connected my car to the PSCAN reader and it is showing:

Wheel speed sensor front left open circuit.

I understand that this could be a break in the wire from the sensor to the ABS unit.

How do I find this break in the wire? Is there a usual location?
Can I use a multimeter to check if the sensor is working?
If so how?

The sensor is a genuine MGR part ...