Mat fixing clips wanted. by itschad1954



itschad1954
Hello people. I'm looking to get some car mat fixing clips for my Rover 75. Looking for four to stop the blighters doing a runner. Anybody got some lying about or can you suggest where i can get them.
Thanks
Trevor

Posted 24 Feb 2013, 21:59 #1 

User avatar
Mick
(Site Admin)
OEM clips have not been available for many moons, I'm not even sure they were sold without mats as they were designed to work with mats with a pre-made and stitched holes, in most cases it was only the drivers side that was secured. However, I have found http://www.ebay.co.uk/itm/CAR-FLOOR-MAT ... 2ebfbdb2f7 which look like they may do the job, fully guaranteed and refundable.

Posted 24 Feb 2013, 22:49 #2 

User avatar
MrDoodles
It may be worth a quick phone call to South Lakes, as they are showing them on their website! ;)

http://www.southlakesminis.co.uk/clipfl ... 14701.html

However, we all know how accurate their website is! :roll:
Image

Posted 25 Feb 2013, 09:35 #3 

User avatar
Mick
(Site Admin)
Well spotted Mr D. They are the OEM type for mats with pre-made holes.

EAK100040.jpg

You do not have the required permissions to view the files attached to this post.

Posted 25 Feb 2013, 11:30 #4 


itschad1954
Thanks fellers. You guys are a wealth of information. Just done some research, apparently on the 1.8 engines ( you know the ones. they suffer HGF (Head Gasket Failure)) because of constantly opening the expansion tank cap to check water levels the O ring seals wear thus encouraging water loss, lose a teaspoonful and its like playing Russian roulette. I just bought a spare with 140 stamped on it,
PART NUMBER: ESR1480 and sourced some Viton O ring seals to replace those on my current cap. The spare will sit in the spare wheel cave.

Posted 25 Feb 2013, 20:35 #5 

User avatar
Bermudan 75
Mick wrote:Well spotted Mr D. They are the OEM type for mats with pre-made holes.

EAK100040.jpg


I think I have some of these, but could not see where they screwed into on the floor.
Image

Posted 25 Feb 2013, 21:24 #6 

User avatar
Mick
(Site Admin)
They screw into the main carpeting wherever the the holes in the mats are set, not the floor.

Posted 25 Feb 2013, 21:56 #7 

User avatar
ceedy
apparently on the 1.8 engines suffer HGF because of constantly opening the expansion tank cap to check water levels the O ring seals wear thus encouraging water loss, lose a teaspoonful and its like playing Russian roulette.

That Sounds like information from out of a Chrisymas Cracker !! :-D :-D
Got one for Me , Then one for her, and now a big one for me again, All BLOO! Well saves on the touch up paint, Now Number one son's Spoilt it all by getting a Firefrost 1.8T

Posted 26 Feb 2013, 09:53 #8 


itschad1954
The above post I put on another site a few days ago after considerable research. I have sourced another expansion tank cap as a spare and will get a set of VITON O Ring seals to replace the ones on my current cap. So two good caps. see ebay listing below.


Rover 75 & MG ZT Coolant Pressure Cap VITON O Ring Seals Expansion Header Tank

271157797086
Item number: from ebay

As regards to these elusive mat fixings, Southlakes minis do not keep the original clips. Up a gumtree then.

Posted 26 Feb 2013, 14:50 #9 


Suffolk Man
i have a pair the same as in the picture. pm me if you want them

Posted 21 Mar 2013, 21:58 #10 


Suffolk Man
post edited as a found a pair

Posted 22 Mar 2013, 12:54 #11 


Top