75ZT Community

DaveyC · Posted 29 Aug 2013, 12:15 #1

I need to gain access to the round black panel, so I can get to the wiring on the fuel pump.

How do I get to it?

Thanks,

Dave

Mick · Posted 29 Aug 2013, 12:22 #2

Pull the front of the seat base sharply upwards on both sides. Rather than remove the base altogether, which is a royal pain, especially refitting. Just prop the seat up as high as possible using a wooden or similar prop. This will allow access to the pump housing. Refitting the seat base is a matter of lowering it to the furthest extent and applying sharp forceful pressure to relocate it.

in-tank-pump-change-diesel.html

DaveyC · Posted 29 Aug 2013, 12:24 #3

Thanks. I thought i was going to have to remove it (as you say a right pain). I'll give it a go, as looking to install FBH (Fuel burning heater.) and I was told the wire for the dosing pump was in there......

Mick · Posted 29 Aug 2013, 12:26 #4

I've added a Know How by Ceedy link above which does advise removal of the seat base but I'm pretty sure it's not necessary.

in-tank-pump-change-diesel.html

The following has pic of the exact location of the panel, as you are just after the wiring I see no reason to remove the seat base completely.

peugeot-diesel-in-tank-pump-fuel-pump-retrofit.html

75ZT Community

75ZT Community

Tourer Rear seat Base Removal? by DaveyC